These steel screws are zinc plated to resist corrosion in wet environments.

Made from 18-8 stainless steel, these screws are chemical resistant.

18-8 stainless steel screws have good chemical resistance.

Stronger and more wear resistant than 18-8 and 316 stainless steel, these screws are mildly chemical resistant.

These square-drive screws are beveled under the head for use in countersunk holes.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Also known as pin-in-hex, install and remove these screws with a tamper-resistant hex driver.

These steel screws are zinc plated to resist corrosion in wet environments.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

Made from 18-8 stainless steel, these screws are chemical resistant.

These steel screws are zinc plated to resist corrosion in wet environments.

Made from stainless steel, these screws are more corrosion resistant than steel, and almost as strong.

With a drilling tip, these metric screws cut their own pilot hole and threads as you fasten them into material.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.

A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.

Commonly used with door hinge hardware, these screws cut threads in material such as aluminum and brass.

Also known as Swageform screws, threads at the tip are designed to grab material for a fast start with low torque in a wide range of materials.

Ribs under the head act as a brake to prevent over-tightening and damaging threads.

Alternating high and low threads minimize driving torque and allow the screw to hold more material between threads for a stronger hold and better strip-resistance than standard drywall screws for wood.

With a square-drive head, these screws attach drywall to metal studs up to 0.036" thick. The head is one-third smaller than other drywall screws.

These square-drive screws have a drill point that powers through drywall and into metal studs up to 0.105" thick. Heads are one-third smaller than those of other drywall screws.

18-8 stainless steel screws have good chemical resistance.

Thread-forming screws press threads into drilled holes for a tight vibration-resistant assembly.