In addition to an audible signal, these alarms flash a high-intensity strobe to draw attention during fire emergencies.

Link multiple detectors in tandem to warn occupants outside the vicinity about potential fire hazards; if one unit is activated, they're all activated.

When the temperature climbs above the temperature rating, the detector sends a signal to your control panel.

Check that your HVAC smoke detector is working properly. Wire these test stations to your smoke detector controller to test difficult to access smoke detectors from a convenient location.

This spray smoke simulates fire conditions to make sure your detectors are working.

Protect your fire alarm stations from damage.

Horns are UL and C-UL listed for indoor and outdoor use in Class I, Division 2, Groups A, B, C, and D; Class II, Division 2, Groups F and G; and Class III, Division 2 hazardous locations.

Sirens can emit both continuous and pulse tones—pulse tones alternate on/off to draw greater attention than continuous tones.

When this horn runs out of air, recharge it with the included pump.

These horns have disposable canisters that can be replaced when the propellant is gone.

Buzzers meet NEMA 4X for protection and corrosion resistance in washdown environments.

Indicate forward or reverse motion with these bells. They mount directly to a vehicle's wheel hub, without switches or wires.

With no moving parts as well as sealed electronic components, this horn is built to last even in wet conditions.