Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Customize the bore of these collars to precisely fit your shaft.

Internal ball bearings allow you to slide a collar onto your shaft in one direction and then automatically lock the collar in place in the opposite direction.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

With larger clamping screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

These metal collars are stronger than plastic shaft collars.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Make quick adjustments to these shaft collars with a lever on the side.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

These collars have two different sides—one locks down like a standard clamping shaft collar; the other has a flush face that you can machine to add slots, holes, and grooves to match your special setups.

To install, slide these one-piece collars onto the end of your shaft.

Mount these collars flush against each other or attach components to either side—the round body has flattened ends with tapped holes.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

To install, slide these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Support the weight of a motor and transfer torque to another shaft at the same time with these couplings.

These couplings have the gripping strength to handle higher torque than most other couplings.

When you need a strong hold and even grip on shafts that are oversized due to finishes, undersized from wear, or uncommonly sized, we’ll make a coupling for you that fits just right. These couplings clamp around your shafts to prevent marring them.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

For hard-to-access shafts that are oversized from coatings or undersized from wear, we’ll get you a coupling in the right size that clamps on as two pieces, so you don’t need to move your shafts or installed components.

With a bellows between two hubs, these couplings handle all types of misalignment and are good for precision stepper and encoder motion-control applications.

Connect shafts and ball screws to high-speed servomotors and stepper motors—these shaft couplings handle four times more speed than standard servomotor couplings.

Designed to grip evenly around your shaft, these couplings provide more holding power than set screw couplings without marring the shaft.

Often used in electronics manufacturing facilities and other extra-clean environments, these shaft couplings are cleaned and individually bagged to keep out contaminants.

Also known as Schmidt couplings, these handle higher angular misalignment than other three-piece couplings. Good for applications with varying shaft misalignment, they're commonly used with conveyor rollers and roller feeds in printing and packaging machines.

A flexible tire on these couplings safeguards components on your shafts by reducing vibration and shock.

A time-saving alternative to strap hangers, these hangers fit a range of material sizes without any cutting and easily adjust after they’re installed.

Install these threaded collars on a metric lead screw to separate and position components, or use them as an end stop to limit travel.