Only for use with 3M dual cartridges, these guns dispense two-part adhesives.

Use these guns to dispense two-part adhesives. Do not use them with 3M dual cartridges.

To simultaneously mix and dispense two-part adhesives, attach these mixer nozzles to a dual cartridge.

Use these plungers with a 3M dispensing gun for adhesives in dual cartridges.

Dispense small amounts of two-part adhesives.

Similar to a caulk gun, these guns are good for small jobs.

Epoxies are the strongest and most weather- and chemical-resistant structural adhesives. They work especially well on metals.

Even when used under water, these adhesives maintain their strength.

Fasten hard-to-bond plastics, such as polypropylene and polyethylene, with these epoxies.

To allow time to adjust and position parts, these epoxies remain workable for at least 90 minutes.

Bond most materials without the strong odor of other epoxy adhesives.

When concrete is saturated or submerged in water, use these adhesives to form strong bonds.

Minimize mess and waste—when you release the handle on these guns, the rod retracts a bit to stop flow automatically.

Adjust air-flow for precise control and smooth material flow—these guns have a built-in pressure regulator with a control knob.

Unlike standard caulk guns, these guns measure just 4" long and don’t have a cartridge rod, so you can use them in snug spaces and around tight corners.

Immerse the nozzle in the sealant and pull back the rod to fill.

The ergonomic design helps reduce fatigue when dispensing one-part adhesives, sealants, and fluids.

These surface fillers can be used on vertical surfaces without sagging. They repair cracked, worn, and damaged surfaces.