To simultaneously mix and dispense two-part adhesives, attach these mixer nozzles to a dual cartridge.

Dispense two-part adhesives with compressed air. Use these guns only with 3M dual cartridges.

Use these plungers with a dispensing gun for adhesives in dual cartridges.

Fill these cartridges with the two-part adhesive of your choice.

Guns are powered with compressed air for controlled dispensing on small and large jobs alike.

Epoxies are the strongest and most weather- and chemical-resistant structural adhesives. They work especially well on metals.

Fasten hard-to-bond plastics, such as polypropylene and polyethylene, with these epoxies.

For invisible bond lines, these adhesives dry clear.

Toughened adhesives are blended with rubber particles for better impact resistance than standard epoxies. They form flexible, resilient bonds.

Even when used under water, these adhesives maintain their strength.

When concrete is saturated or submerged in water, use these adhesives to form strong bonds.

These surface fillers can be used on vertical surfaces without sagging. They repair cracked, worn, and damaged surfaces.

Unlike standard caulk guns, these guns measure just 4" long and don’t have a cartridge rod, so you can use them in snug spaces and around tight corners.

Let compressed air do the work for you when dispensing sealants from cartridges.

Adjust air-flow for precise control and smooth material flow—these guns have a built-in pressure regulator with a control knob.

Immerse the nozzle in the sealant and pull back the rod to fill.

Protect circuit boards and other electronics from fire and heat.

Protect circuit boards and other electronics where high heat is a concern but you don’t need to transfer that heat elsewhere. These compounds are a good middle ground between standard epoxy compounds and heat-transfer compounds.

Clear enough to read through, these UV-resistant potting compounds allow optimal light transmission for use with LEDs, solar cells, and fiber optics.

Combine the flexibility of silicone with the durability of standard epoxy—these compounds are great for protecting sensitive electronics that need to flex or expand and contract.

Thinner than potting compounds, these rigid and wear-resistant coatings flow easily into small spaces between electrical components. Use them to secure and insulate hardware on printed circuit boards.