Mount add-on heads in remote areas to extend emergency lighting. Hardwire each head to an emergency backup light; they operate on any of the voltages listed. These add-on heads have built-in LEDs so they last longer, are more efficient, and generate less heat than other technologies. Rated for use in damp locations, these heads withstand exposure to humidity and moisture. Heads adjust to any angle to direct light where needed.

These lights are UL listed for Class I, Division 2, Groups A, B, C, and D for use in environments where ignitable concentrations of hazardous material occur infrequently, such as in the case of an accidental spill or failure of a ventilation system. They withstand acetylene, hydrogen, ethylene, and propane. Lights can be hardwired to operate on any of the voltages listed. They have a low-voltage disconnect so they won’t drain the backup battery. Use the test switch to check that the heads and battery are working properly. Heads adjust to any angle to direct light where needed. They cannot be sold to the listed areas due to energy efficiency requirements.

Connect the battery pack to your existing fluorescent light to convert it into an emergency backup light. They include a test switch to check that the bulbs and battery are working properly.

Kits that cannot be sold to the regions listed are resitricted by local energy efficiency requirements.

Rated NEMA 4X, these lights are protected from corrosion and washdowns. They have built-in LEDs so they last longer, are more efficient, and generate less heat than other technologies. Lights can be hardwired to operate on any of the voltages listed. They have a low-voltage disconnect so they won’t drain the backup battery. Use the test switch to check that the heads and battery are working properly. Heads adjust to any angle to direct light where needed.

Mount add-on heads in remote areas to extend emergency lighting. Wire up to three of these heads to your emergency backup light.