These pulleys are cast iron.

Increase efficiency, vary speed, and extend the life of your drive by changing the pitch on these pulleys.

Also known as step-cone pulleys, these have multiple groove sizes so you can quickly change rotation speed by moving your belt to a different groove.

These pulleys have the same sizing versatility as quick-disconnect pulleys, but they create a tighter grip on bushings for use in high-torque applications.

Pulleys are anodized aluminum, which is more corrosion resistant than steel.

Pulleys are XL series (extra light) and have trapezoidal teeth.

Carry heavy loads without slippage—pulleys mount with a bushing for a more secure grip on the shaft than set screws.

Anodized aluminum has good corrosion resistance.

Move heavy loads without slippage—pulleys mount with a bushing for a more secure grip on the shaft than set screws.

Add these free-spinning pulleys to your timing belt setup to minimize vibration and keep belts from wearing out.

Made of aluminum, these pulleys have good corrosion resistance.

Made of iron, these pulleys are strong enough to carry extra heavy loads.

Move belts forward and backward or stop and start them in precise positions, especially in areas where rust is a concern.

Keep high torque drive (HTD) timing belt systems running tightly with these idler pulleys. Made with built-in, free-spinning ball bearings, they're installed on shafts or belt tensioners to remove slack from timing belts.

For higher speed or higher torque applications, these GT series timing belt pulleys provide a more precise fit than HTD pulleys. Use them where accuracy is critical, such as in storage and retrieval systems or in robotics.

Teeth are curved and set in an offset pattern for high strength with 25% less operating noise than pulleys and belts with trapezoidal teeth.

Mount these pulleys directly onto a shaft to transmit rotary motion and torque.

Also known as paper-plant pulleys, these are made of a paper-fiber composite that minimizes belt slippage and wear.

If none of our standard guards fit your chain or belt system, we'll create one to suit your needs. Guards are steel and fit sprockets up to 48" apart.

A rubber coating, also known as lagging, increases friction for a better grip on the belt.

The corrosion-resistant stainless steel construction makes these pulleys suitable for washdown applications.

Sprockets transmit power to drive belting.