We will reply to your message within an hour.
More
The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.
These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.
Drill holes up to 1 1/2" in diameter.
These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.
These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.
Also known as A-taper bits, these fit rotary hammers with a taper-shank chuck.
Use these diamond-coated hollow bits for wet drilling of masonry, concrete, and rebar with a drilling rig.
Use these bits with handheld power drills, drill presses, and hammer drills.
The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.
A built-in stop ensures repeatable drilling depths for installing drop-in anchors.
Unlike traditional wire-installing drill bits, you do not need to strip the end of the wire when using one of these bits. After drilling, insert the wire into the bit's hollow shaft and pull through the hole.
A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.