We will reply to your message within an hour.
More
These jobbers'-length bits have the rigidity and length required for most applications.
Also known as screw-machine and stub-length bits, these provide maximum rigidity for drilling straighter holes than jobbers'- and maintenance-length drill bits.
The short flutes provide increased rigidity for drilling straighter holes than standard extended-length drill bits.
Also known as mechanics' bits, these are shorter and more rigid than jobbers’ bits but longer than short‐length bits.
The short flutes on these jobbers'-length bits provide increased rigidity for drilling straighter holes.
Access hard-to-reach spots and drill deep holes.
Use these bits for general purpose drilling in most material.
Insert these bits directly into power screwdrivers, impact drivers, and other tools that accept 1/4" hex shanks.
All have a 1/4"-28 threaded shank which installs directly into the threaded spindle on a compatible drill.
Three sharp points allow these bits to drill accurate straight and overlapping holes, even across the grain. Also known as brad-point bits.
An open spiral-flute design clears chips quickly, so these bits can bore smooth, deep holes through construction lumber, railroad ties, and utility poles. Also known as pole or ship auger bits.
The screw point draws the bit in, quickly boring holes without applying pressure.
When one end becomes worn, reverse the bit to use the other end.
These bits have short flutes and a sturdy construction which prevent snagging that deforms sheet metal and thin-wall tubing.
Use for drilling in most metal.
Place a washer with an ID of the desired hole size over the bit and it acts as a stop to prevent the bit from drilling a larger hole.
Unlike traditional wire-installing drill bits, you do not need to strip the end of the wire when using one of these bits. After drilling, insert the wire into the bit's hollow shaft and pull through the hole.
Also known as mechanics' bits, these are shorter and more rigid than jobbers’ bits but longer than short-length bits.
Designed to lift chips out of the hole, these bits reduce clogging and improve coolant flow.
No need to create a starter hole—the drill point is incorporated into the countersink flutes.
To remove the need for a starter hole, the drill point is incorporated into the countersink flutes.
For general purpose use.
These counterbores are attached to a drill bit for drilling and counterboring in a single step.
Enlarge existing holes without changing their depth.
Enlarge existing holes without changing the depth.
Drill and tap a variety of hole sizes. These taps and drill bits are for use on metal and plastic.