Minimize damage to your work surfaces with these brass punches, which are softer than steel punches.

The rounded tip of these punches fits into the open ends of hollow and spring pins to protect them from damage during removal.

Loosen pins and rivets before removal.

The rounded tip of these punches fits into the open ends of hollow and spring pins to protect them from damage during removal.

Knock out pins and rivets that have already been loosened. These tools are also known as pin punches.

Made of materials that are Factory Mutual approved, these nonmagnetic, corrosion-resistant tools inhibit sparking. They satisfy OSHA requirements for nonsparking tools.

A hammer and punch in one, this tool knocks out pins, rivets, and bolts.

Contains pin-loosening, pin-removal, and center-marking punches as well as chisels.

The handles of these assorted picks have a magnet at the end to pick up small steel objects. Use to hold and position wire, springs, and other small parts.

Sets include a handle and an assortment of tips for holding and positioning wire, springs, and other small parts.

Hold, separate, and position small parts with one tool. These sets include assorted picks with a different tip at each end.

Use these tools to hold, separate, and position wire, springs, and other small parts.

Made of beryllium copper that is FM approved, these picks satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Solder won’t stick to these assorted picks, which are used for positioning circuit board components.

Avoid nicking or scratching sensitive components. These picks are good for adjusting small wires or separating press-fit plastic components.

An insulated handle protects against accidental contact with live electrical circuits. These picks are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

The assorted picks in these sets are used to install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

Install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

A precision tip on each end of these picks lets you install, extract, and position parts around delicate circuits and components with one tool. The needle-sharp tips are similar to dental tools.

Similar to dental instruments, these needle-sharp picks are suitable for work around delicate circuits and components.

Sets include an assortment of premium tweezers that are Swiss made to tight tolerances for the perfect tip alignment required for work under magnification.

Often used to grip objects during thermal, chemical, and soldering processes, these zirconia ceramic tweezers are highly heat and corrosion resistant.

Sets include an assortment of general purpose tweezers for gripping a variety of objects.

Extra-long tips provide access to material in hard-to-reach areas.

These assorted tweezers hold small parts without the need to apply pressure. Squeeze to open the tips and release to close them.

Hold small parts without the need to apply pressure. Squeeze these tweezers to open the tips and release to close them.

Protect against accidental contact with live electrical circuits. These plastic-insulated tweezers are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Choose plastic tweezers for a soft, nonmarring grip. These tools are corrosion resistant and nonmagnetic.

Unlike other tweezers where the tips come together, these tweezers have tips specially designed to remove chips and other delicate components from circuit boards.

These assorted tweezers have tips that can be replaced when they become worn. Tips are carbon fiber, which insulates against heat and won’t nick or scratch components.