These metal collars are stronger than plastic shaft collars.

Customize the bore of these collars to precisely fit your shaft.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Make quick adjustments to these shaft collars with a lever on the side.

Tighten the set screw to bite into an unhardened shaft for a secure hold.

Secure items to either side of these collars—each half has a flat end with a tapped hole

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

For hard-to-access shafts that are oversized from coatings or undersized from wear, we’ll get you a coupling in the right size that clamps on as two pieces, so you don’t need to move your shafts or installed components.

When your shafts are not close enough to use standard couplings, these have the length to bridge the gap.

Often used in corrosive environments to support pipe passing through walls and floors, these collars are 303 stainless steel and sized specifically for a tight fit around pipe.