Accommodate ties in any direction with these rings that swivel all the way around and pivot 180°.

These rings mount flush and fold down when not in use to eliminate obstructions.

Adhesive on the back holds these rings in place.

Also known as footman's loops, use these guides to prevent webbing from twisting, or as anchor points in tie-down applications.

Use these plates where full lengths of track won't fit to create one anchor point.

These rings pivot to secure loads in various directions.

Hang, pull, and secure loads. These rings are good for general non-lifting applications.

Use for three-sided connections. Flat sides ensure webbing and strapping lay flat, so they won't slide and bunch.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

Best for attaching different widths of webbing and strapping, the flat sides ensure they lay flat and won't bunch or slide.

Also known as C-links, the notch in these links lets you slip additional links on or remove links quickly.

A bolt fastened with a nut and cotter pin makes these shackles more secure than screw-pin shackles.

Since they close with a screw pin, these shackles are quick to install and remove by hand, but should only be used in low-vibration environments where they’ll remain stationary. Their narrow opening restricts the movement of wire rope and chain.

Indentations in the shackle body hold the head of the pin in place once fastened.

Indentations in the shackle body hold the head of the pin in place once fastened.

Choose these hoist rings when you need to lift your load from the side.

Hold rope more securely than nonlocking and slide-release carabiners. While these carabiners are not as secure as screw-locking carabiners, they are easier to open.

The most secure carabiner we offer, these carabiners won’t accidentally open when rope slides because you need to unscrew the latch to unlock them.

Hook these straps to your harness to add length to the existing D-ring and make it easier to attach a fall-arrest lanyard.

Also known as tether loops, these have a heat-shrink sleeve for gripping your tool and a D-ring for attaching to a tool lanyard.