Install these covers without removing switches from the panel—covers fit over mounting hardware.

Protect toggle switches from moisture and dust by replacing panel mounting nuts with these rubber covers.

Made of stainless steel, these covers protect push-button actuators from impact.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Shorter and thinner than other safety limit switches, these are sized to fit tight spaces.

Often used on conveyor systems and bin filling operations, these switches have the rapid-closing action of a snap-acting switch but have a large actuator for sensing larger objects.

These switches actuate with the slightest push for a high degree of accuracy. They're rated IP67 for protection from wet locations and temporary submersion.

These switches actuate with the slightest push for a high degree of accuracy.

Rated IP67, these switches are protected from temporary submersion. When an object in motion comes into contact with the actuator, it sends a signal to open or close a circuit.

Stack these slim switches together, or fit them into tight spaces. They're rated IP67 for protection from temporary submersion.

Safely open or close a circuit near ignitable gases and dust—the housing on these switches seals in anything that could ignite flammable material.

Start and stop motors outdoors and in other wet environments.

Rated NEMA 4, these switches are protected from washdowns.

Prevent motors and other equipment from overheating or failing from not having enough voltage. When the supply voltage falls below 35% of the rated voltage, these switches will automatically turn off to protect the circuit from undervoltage.

Small yet mighty, these switches are about as tall and wide as an index card yet durable enough to mount directly to a wall.

With a housing that’s designed to contain an explosion, these switches are safe to use in areas where ignitable concentrations of flammable or combustible gas, dust, or fibers may be present.

Protected by a steel enclosure, these switches withstand tougher conditions than switches in a plastic housing. Also known as safety switches, they have quick-make/quick-break action to eliminate arcing and prolong switch life.

The IP66 rated housing not only shields these switches from washdowns but also makes them durable enough to be mounted outside of an electrical panel.

Mount electrical components along your strut channel to bring power to new locations.

Close off unused switches and outlets.

Pair wall plates and adapters to create a custom cover for existing receptacles and switches to give them a rejuvenated look, no rewiring required.

Keep switches and outlets under cover for protection from dust and dirt. These stainless steel plates resist corrosion and have a sealing gasket to keep out moisture.

Create various data connector configurations by choosing adapters to snap into the ports in these wall plates.

Close off unused outlets.

Close off unused outlets.

Close off unused outlets.

Close off unused outlets.

Close off unused switches.

These corrosion-resistant covers can withstand rain, snow, and wet conditions without being damaged.

Close off unused outlets.