These switches withstand temporary submersion.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

Never worry about your pendant switch losing power. These pendant switches generate enough power from pushing the button to send a signal to a receiver up to 330 feet away.

Immediately cut power by pulling the cable.

Tug on the cable anywhere along your line to immediately cut the flow of power. This multi-functional unit also sends a signal to restart machinery with the push of a button, doing the job of two units in one.

Connect these switches to a cable to control circuits from a distance. They're typically used to turn off production lines and material handling systems.

Rated IP67 for protection from dust and temporary submersion.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

Rated IP67, these switches are protected from temporary submersion.

Apply pressure from any direction to actuate these switches.

Step on these switches for hands-free actuation in an area with frequent washdowns.

Install in 14 mm dia. cutouts.

Install in 8 mm dia. cutouts.

Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.

Maximize the space in a panel—these switches are half the size of most toggle switches.

Suitable for areas with space limitations, these switches have a low profile and a small footprint. They lay flat or mount to a wall.

Install these key switches in 3/4" dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Maximize space in a panel with these miniature switches.

The lever sticks out further than a push button, making it easy to identify the position of these switches.

Made with stainless steel conductors, these switches resist corrosion in damp areas. They’re less than 1/4” thick, so they’ll fit under floor mats and in other tight spaces.

These narrow switches are also thin enough to be hidden under carpeting or installed anywhere space is limited.

Use fingerprints to confirm the identity of personnel before granting access to secure areas or equipment.

Customize the length of these switches by cutting them from a 50-foot roll.

An infrared light beam senses the lightest finger contact to switch a circuit on or off.

Rated IP67 and NEMA 6, these switch mats withstand washdowns.

Combine a foot-pedal actuator with a switching mechanism to build a complete switch.

Combine a push-button actuator with a switching mechanism to build a complete switch.

The power switch to these outlet strips is on an extension cord, so you can control power even when the strips are in hard to reach places, such as under a desk.

Save energy by automatically turning off unused outlets—the master outlet controls the follower outlets and shuts off power to those outlets when a device plugged into the master is turned off.

Keep personnel safe from electric shock with ground fault protection.

Power computers, lab equipment, and office machines that have IEC connections.

No need for mounting hardware—these outlet strips have magnets on the back to stick to steel walls, cabinets, and other magnetic surfaces.

After a power failure, these cords must be manually reset, preventing unexpected equipment startup.

Plug these cords into a vehicle socket to charge devices that run on AC voltage.

Keep personnel safe from electric shock with these cords.

Reduce cable strain caused by equipment hanging from drop-down cable.

Lengthen pull-chain light switches.

These chargers are for use with most DeWalt batteries, except Univolt batteries.

Energize Milwaukee tool batteries with these chargers.

Use these chargers with Black & Decker batteries.

Charge multiple devices at once.

Bring batteries to these chargers for maintenance.

Charge batteries even in wet environments—a sealed housing keeps water out.