More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

These 18-8 stainless steel anchors have good chemical resistance.

An open-end cap nut provides a finished appearance.

These 18-8 stainless steel anchors have good chemical resistance.

A zinc plating provides corrosion resistance in wet environments.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

A hex head allows for a secure grip with a wrench.

A tamper-resistant nut prevents unwanted removal of the object you are anchoring.

These 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Use with any type of sheet metal or wood screw.

18-8 stainless steel anchors have good chemical resistance.

These steel anchors are available with corrosion-resistant finishes.

For narrow holes and small cavities where toggle anchors won't fit.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.

Drill holes up to 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

Also known as A-taper bits, these fit rotary hammers with a taper-shank chuck.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.

A built-in stop ensures repeatable drilling depths for installing drop-in anchors.

Use these bits with handheld power drills, drill presses, and hammer drills.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.