Use these springs in noncorrosive environments.

Use these steel springs in noncorrosive environments.

Made of stainless steel, these springs are more corrosion resistant than steel compression springs.

These springs meet MS24585 and come with a traceable lot number and material test report.

A lightweight, nonmagnetic, and nonconductive alternative to metal springs, these plastic springs are better for corrosive environments and applications where metal springs cannot be used, such as in sensitive imaging equipment and machines where stray electrical current may cause damage.

These springs handle higher loads than standard fastener-mount compression springs. Secure by inserting a fastener through the hole at the base.

Differently sized mounting holes on either side allow for mounting flexibility.

These springs follow the Raymond die spring color code.

Use these spring-tempered steel die springs for low-cycle applications such as trimming and stamping.

Protect dies from damage caused by spring failure. Cages enclose springs to retain fragments if they break.

Use these steel springs in noncorrosive environments.

These steel springs meet MS 24586 and come with a traceable lot number and material test report.

Use these steel springs in noncorrosive environments.

Use these steel springs in noncorrosive environments.

Made of stainless steel, these springs are more corrosion resistant than steel extension springs.

These fabric-covered rubber springs stretch to up to three times their original length—much farther than traditional extension springs, tie downs, and shock cords.

Multiple rows of waves allow these springs to handle higher loads than standard wave disc springs.

Use these high-carbon steel springs in noncorrosive environments.

A gap allows these springs to compress without widening, so they won't bind or deform when used inside a housing with tight clearance.

These springs withstand temperatures from -400° to 1100° F. All are 718 nickel, a high-strength, corrosion-resistant alloy that's also known as Inconel.

Install these springs, also known as bearing preload washers, against ball bearings to reduce noise and unwanted movement along the shaft.

These springs meet MIL-W-12133.

Made of stainless steel, these springs are more corrosion resistant than steel springs.

Raised tabs, known as fingers, enable these springs to compress without widening, so they won't bind or deform in housings with little clearance. Use with ball bearings in precision and high-speed drive assemblies to reduce noise, vibration, and wear.

When compression springs are pushed together, they push back to return to their original length. Commonly used in shock absorbers and to secure batteries, they're are easier to push together than die springs.