Stop slow-flowing and weeping leaks in concrete. These crack fillers begin to harden in three to five minutes to create a permanent fix that won't shrink.

Polyurethane fillers are thin to penetrate deep into cracks. When fully cured they create a seal that can withstand pressure of up to 2,000 psi. Apply with a standard caulk gun (sold separately). For especially large cracks, use a packer (sold separately) with a grease gun or a grout pump.

Stop active leaks of up to 50 gallons per minute in concrete, brick, and stone. These crack fillers begin to harden within seconds to create a permanent fix that won't shrink. When fully cured they create a seal that can withstand pressure of up to 2,000 psi. Apply with a dispensing gun (sold separately). The size listed is the combined total of the two parts. A mixer nozzle is included.

Fill in and shape horizontal, vertical, and overhead concrete surfaces, such as steps and columns.

Epoxy surface fillers are nonsagging. They resist oil, grease, water, alkalies, and chemicals. Application time, after mixing, is 1 hour. The size listed is the combined total of the two parts.

Mix this two-part epoxy—a resin-aggregate blend and a pigmented hardener—to create a grout that resists chemicals, such as acids, alkalies, salt water, and common solvents and cleaners. Its lightweight formula makes this grout easy to spread. Use in horizontal or vertical joints—grout won’t sag or shrink. Apply with a grout float. It can be cleaned up with water when wet; it doesn’t require a sealer once it cures. The size listed is the combined total of the two parts.

Used on ceramic, concrete, and stone floor and wall tiles, grout consists of fine sand, masonry cement, and coloring. Apply with a grout float.

Acrylic grout does not require mixing. It resists shrinking, cracking, and staining.

Keep the surface of your porcelain fixtures looking like new.

Filler repairs large chips and cracks. Sand and finish with glaze.

Glaze touches up small chips and scratches.

For strong bonds, clean and degrease surfaces before applying adhesives. These cleaners are NSF registered K1 for use in non-food-processing areas within food-processing facilities.

Certificates with a traceable lot number and product shelf life are available for these products. Download certificates from ORDER HISTORY after your order ships.

Often used to prepare parts for painting or powder coating, these water-based cleaners remove dirt, grease, metal residue, and mold-release lubricants. You can also use them to clean stainless steel prior to passivation. Free of fragrances and dyes, they rinse clean without leaving a residue. They contain corrosion inhibitors for long-lasting surface protection. Clean parts by soaking, scrubbing, or using a pressure washer.