Snap these screws into panels up to 0.125" thick—no tools are required for installation.

The base flares out during installation, creating a backside flange in hard materials and near edges in panels up to 0.312" thick. Install with a flare-in installation tool and an arbor press.

Rivet these wing head nuts into thin panels for a flush fit. They can be mounted without space between panels. A quarter-turn locks and releases access panels, doors, and covers.

Press these wing head nuts into the backside of a panel in applications where you have access to both sides of the panel. A quarter-turn locks and releases access panels, doors, and covers.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Retract the nose by pulling the knob.

Install by hand or with a hex key in low-clearance applications.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.

Two holes in the plate allow these plungers to be mounted to a flat surface.

A smooth ball handle is easy to grip and won't catch on other parts.

These latches have a spring-wire cam that slips under a receiving catch on a cabinet body to create tension and hold cabinet doors and drawers closed.

The knob on these latches is easy to grip and less likely to snag straps or clothing than T- or L-handle latches. Also known as compression cam latches, these latches create a tighter hold than a traditional cam latch, so they’re useful for doors with a seal.

To fit in tight areas, these latches have a knob instead of a handle. Add a padlock for extra security.