Also known as C-style and crescent rings, these rings have a small shoulder to fit in tight spaces.

Also known as poodle rings, these thick rings have "ears" that form a large retaining surface to withstand stronger forces than other side-mount retaining rings.

Open these rings, pass them over the end of a shaft, and release to spring into the groove.

These rings meet military specification MS 16624.

For a smooth profile and better clearance than standard external retaining rings, the lugs on these rings point inward.

No groove required—press these rings onto the end of a shaft for a firm grip.

The wide flange provides better load distribution than standard external push rings and can be used to cover oversized holes. Also known as thread cutting nuts.

Slide these rings into place with one twist—no tools required—for applications with high thrust loads.

These coiled rings can be wound into place on a shaft without tools.

Also known as X-washers, place these rings into the groove and squeeze tight with pliers to form a 360° closure.

Also known as constant-section rings, these rings have open ends and a profile that does not taper like other external retaining rings. Use them with linear bearings on support rail shafts.

For a smooth bore and better clearance than standard internal retaining rings, the lugs on these rings face outward.

The curved design of these rings works like a spring, taking up play for a tight hold.

Slide these rings into place by hand with a single twist for applications with high thrust loads.

Thicker than standard spiral rings, these rings withstand greater forces.

Assortments include pliers to install external rings.

These assortments include pliers to install external and internal rings.

Wind these retaining rings into a groove—no tools required for installation.

Slide the retaining ring in between the jaws of the tool and push the ring onto a shaft.

Hold open retaining rings without holes, such as flat- and pointed-tip lock rings. Also known as Eaton-style, constant-section, and horseshoe snap rings.

Often used to hold open retaining rings without holes, these pliers have a forged construction for strength, durability, and a long life.

Install and remove rings inside a bore or around a shaft. Adjust the jaw to switch from internal to external retaining ring types.

The forged construction provides high strength for durability and long life.

The forged construction provides high strength for durability and long life. Use the included hex key to change tips for a different size or angle.

The pliers in these sets have a handle that locks in place to hold rings open or closed for easier installation and removal. Change tips to use a different size or angle.

Insulated handles protect against shock from accidental contact with live electrical circuits. These pliers are tested to 1,000 volts to meet ASTM F1505.

Working with large retaining rings is easier with a T-handle. Turn it to open and close the jaws. Change tips for a different size or angle using the included hex key.