A thumb screw instead of a slotted screw allows you to install these clamps without any tools.

One clamp fits a wide range of diameters, so you can always have the right size on hand.

Make quick changeovers without sacrificing a tight seal.

Clamps offer extra holding power in high-torque applications.

Installing these clamps is a snap—push their interlocking teeth together with your fingers, then squeeze tight with pliers. To remove, use pliers to push sideways and separate the teeth.

Not as bulky as our other constant-tension clamps, these round-wire clamps easily fit in cramped spaces. Use in low-pressure applications.

These clamps have a wider band than other constant-tension clamps, which provides more coverage and reduces the chance of leaks.

Made of our most corrosion resistant stainless steel, these worm-drive clamps stand up to harsh acids and chemicals. Their band is smooth and has rolled edges, so they won’t cut into your hose or tube.

Made of nylon, these clamps have excellent corrosion and chemical resistance, don’t conduct electricity, and weigh less than metal clamps.

Also known as bridge clamps, these worm-drive clamps align with the spiral support on wire duct hose to provide a tight seal.

Clamps come packed in a box with individual compartments for each clamp size. To make sure they won’t cut into hose and tube, they have a smooth band with rolled edges.

Create 2" diameter and larger smooth-band worm-drive clamps.

The bolt design provides high strength and creates a 360° seal to prevent leaks.

Remove the bolt and flip open the hinged bridge to install.

Flip up the slotted hex head screw to quickly release the band. These clamps have rounded edges and a smooth interior, so they won’t cut into hose and tube materials.

These plastic hangers prevent corrosion caused by metal-to-metal contact. Push them closed for a more secure hold on material than loop hangers.

A time-saving alternative to strap hangers, these hangers fit a range of material sizes without any cutting and easily adjust after they’re installed.

A versatile solution for temporary hanging of pipe and tubing at work sites as well as anywhere welding and fastening are not possible. Feed material through the strap, then use the D-rings to adjust the hanging height.

Hang cable and other flexible material beneath wire to prevent it from sagging and swaying. To install, hook the two ends of the ring around the wire—no fasteners required.

Slide these clamps into strut channel and snap closed for quick installation with no tools required. They are noncorrosive, nonconductive nylon.

Keep an assortment of large and small cable holders on hand for holding and routing cable across your surface.

Bundle cables outdoors with these ties that withstand exposure to UV rays and water.

These ties stretch to hold material tightly without slipping.

Create custom-length ties from a roll with hook on one side and loop on the other.

Easily open and cinch closed parallel bundles.

These ties are flexible, reusable, and adjustable for delicate bundles or bundles that frequently change in size.

A textured tab on the end makes these cable ties easy to yank open and cinch shut, even when wearing gloves.

Route and organize wire, cable, and hose along your DIN rail. Unlike zip ties, these cable ties can be temporarily undone to add or remove material.

Mount bundles to surfaces with a screw or fastener. Since the mounting grommet on these ties is not accessible after material has been bundled, these ties are best for a permanent installation.

A swivel between the hook and loop and cable tie lets you rotate your bundle 360°.