Also known as pipe plug sockets, these sockets have a square shape that provides the best possible grip on square fasteners and prevents rounding.

Turn multiple shapes and sizes of fasteners with a single socket.

Quickly position these sockets on square fasteners.

Made of aluminum-bronze, these sockets satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Shaped and sized for compatibility with wheel bearing locknuts on trucks and trailers, the sockets in these sets make it easy to install and remove locknuts.

Turn 90° elbow fittings that are in tight spots with the sockets in these sets.

Connect one of the heads in these sets to a socket extension to reach an obstructed fastener, then turn the fastener without removing and repositioning the wrench head.

Turn square-drive fasteners in several sizes with these socket sets.

Push the square drive through the adapter to change size.

These adapters are insulated to protect against accidental contact with live electrical circuits. They are tested to 1,000 volts to meet IEC 60900.

Safely lengthen the reach of your socket while working near flammable vapors and combustible residue.

Extend your socket's reach.

Bend these socket extensions around obstructions to turn hard-to-reach fasteners.

Reach a variety of spots with the confidence that your extension won’t disengage.

Tighten and loosen fasteners in hard-to-reach spots with a variety of extensions that lengthen the reach of your socket.

Attach your square-drive sockets to drills, powered screwdrivers, and other tools that accept a hex shank.

Convert from one square drive size to another.

Attach your impact square-drive sockets to power drills, impact drivers, and other tools that accept a hex shank.

Reach a variety of spots by keeping common extension lengths on hand.

Attach one of these extensions to your impact socket to turn fasteners in hard-to-reach spaces.

These adapters, which convert from one square drive size to another, were designed to tolerate continuous use with impact tools in high-volume production and assembly.

Use these adapters to connect sockets to impact wrenches and other power tools—they’re designed to tolerate continuous use in high-volume production and assembly.

The pin on these retainers is permanently connected to the ring, so they're less likely to dislodge when used with an impact wrench compared to two-piece retaining rings.

A ratchet mechanism allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

Turn lug bolts on car and truck wheels. These wrenches have a different socket size at each end.

The slim head fits into tight spaces and around thin fasteners.

One head is angled for access to hard-to-reach fasteners. These are also known as ignition wrenches.

Sized for working on small equipment, these wrenches are 4 1/8" long with a slim head and handle.

Made of aluminum-bronze that is Factory Mutual approved, these wrenches inhibit sparking and are nonmagnetic and corrosion resistant. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

These lightweight tools are also known as AN (Army-Navy) wrenches.

Strike the handle with a hammer to break stuck fasteners free. These are also known as slugging wrenches.

Sized for working on small equipment, these wrenches are 4 1/8" long with a slim head and handle.

The opening shape makes more contact with fasteners for a better grip than standard open-end wrenches. These tools are also known as flare-nut or line wrenches.

Made of stainless steel, these wrenches have excellent corrosion resistance.

The slim heads fit into tight spaces and around thin fasteners.