The male pipe threads on these fittings have a sealant applied for extra protection against leaks.

The threads on the tube end of these fittings are Class 3A or 3B and adhere to tighter tolerances than other 37° flared fittings.

Use these fittings at pressures up to 9,700 psi. Also known as instrumentation fittings, they are made to tight tolerances for use in high-precision applications. They are compatible with Swagelok®, Let-Lok, and Parker A-Lok fittings.

Use these nuts with a sleeve and fitting to provide a tight metal-to-metal seal on steel tubing that is flared to 37°.

The external hex bolt on these fittings allows for easy installation in cramped spaces.

A tube adapter sits flush against the flat face of the fitting so you can slide the steel tubing and fitting sideways to disconnect in cramped spaces. Also known as zero-clearance fittings.

The external hex bolt on these fittings allows for easy installation in cramped spaces. They are also known as banjo-style fittings and JIC (Joint Industrial Council) fittings. They provide a tight seal on tubing that is flared to 37°.

Also known as live swivels, these fittings swivel continuously 360° before and after installation. This not only makes installation easier, but also eliminates the twisting and kinking that can cause hose failure. Fittings are threaded on both ends so you can connect them directly to a threaded hose or to pumps, cylinders, and other equipment in your hydraulic system.

Crimp these fittings onto hydraulic hose for a permanent, leak-tight connection. Since they crimp on, they handle higher pressure than screw-on fittings.

Create or repair D.O.T. hose assemblies in the field with just a wrench and a vise, no crimper required.

Although only half the weight, this hose resists wear and tear 240 times better than our standard rubber hydraulic hose. It comes with female threaded fittings already attached, so it’s ready to use right out of the box.

For frequent connections, this hose has a socket end that's faster to connect and disconnect than a threaded fitting. This hose bends twice as sharply and resists wear and tear 80 times better than our basic hydraulic hose, thanks to its two layers of blended rubber.

Internally reinforced with four steel wire spirals, this hose resists bursting from rapid changes in pressure and flow. To save you time, this hose comes with female threaded fittings already attached.

Cut the hose to your desired length and attach the fittings. You don't need any special equipment to install.

Heat chemicals to prevent them from freezing or becoming too thick. With a self-regulating heating wire, the liquid inside this hose stays warm and keeps flowing.