Simply adhere this silencer to the door frame—no need for an installation hole. Doors close firmly yet quietly with this silencer. It also eliminates the rattling of doors against their frames. Made of rubber, this silencer resists abrasion. It requires _1/8" of clearance between the door and the frame.

Designed to withstand impact in high-traffic areas, these stops have an anchor that mounts in a hole and sets with grout. Install them in concrete floors to protect walls from large doors in warehouses and manufacturing areas. Made of rubber, these stops are abrasion resistant. They're also nonmarring.

These stops have a metal stem and base for strength and durability. Use them to protect walls from doors in high-traffic applications. All have a rubber pad, which is abrasion resistant. Mount them with the included screws.

Remove the pin on your door's hinge, slide it through one of these stops, and then insert it back into the hinge to set and adjust the door's opening angle. Both stops have nonmarking rubber pads, which are abrasion resistant. Use the locking screw or threaded stud to make your adjustments.

Simply screw these bumpers into baseboards with the attached self-tapping wood screw to prevent doors from damaging walls. All of these stops have a nonmarking rubber pad, which is abrasion resistant.

Keep sliding doors and panels from damaging walls and door frames. Mount these stops with screws.

Protect door knobs and other hardware from damage caused by carts, dollies, and other equipment. Mount these bumpers on doors next to, above, below, or over the item you wish to protect. Install them with screws.

Protect large swinging doors where carts and vehicles are used to push the door open. These plastic bumpers are commonly used on two-way swinging doors. All are chemical resistant and won't dry out and become brittle when exposed to UV rays. Mount with the included screws.