They may look like normal pliers, but these tools have a built-in crimping die.

The ratchet applies the correct pressure to ensure a complete crimp every time.

Dies snap in and out of this tool, so you can quickly change from crimping one electrical connector type to another.

The ratchet in these crimpers applies the right amount of pressure to ensure a complete crimp in wire ferrules every time.

The ratchet on these tools applies the right amount of pressure to make sure the crimp is complete every time. Since you insert the wire ferrule from the front, they're useful in tight spaces.

Crimp pin-and-sleeve contacts in connectors.

The ratchet applies the correct pressure to ensure a complete crimp every time.

Switch out the dies to make quick, repeat crimps on a wide range of connector sizes.

The high-pressure pumping system in these crimpers creates enough force to crimp large copper and aluminum lugs.

Strip wire and crimp connectors with one tool.

The ratchet applies the correct pressure to ensure a complete crimp every time.

The elongated nose on this tool reaches into tight spaces.

Crimp insulation-piercing connectors, commonly referred to as IDC connectors, onto flat ribbon cable.

These tools lock onto your material to prevent them from opening while bending and crimping.

Rounded jaws reduce damage to aluminum and other lightweight metal.

Offset handles allow you to use these tools in tight spaces.

Additional features, such as wire terminal crimpers, enable you to perform a variety of electrical wiring and installation work with a single tool. Also known as lineman’s and combination pliers, these pliers have long jaws that pull, bend, and cut wire and other small workpieces.