Offering high electrical conductivity and formability, 110 copper is 99.9% pure. Also known as ETP copper, it's often used in electrical applications, such as for bus bars and wire connectors, as well as for flashing, gaskets, and rivets.

An ultra-thin layer of silver makes these bars slower to tarnish than unplated copper to provide low electrical resistance at contact points over time.

Polished on one side to a reflective, mirror-like finish.

Also called tellurium copper, 145 copper contains tellurium, which makes it more machinable than all other copper while maintaining good corrosion resistance and high electrical conductivity. It’s often used for transformer and circuit-breaker terminals, welding torch tips, and fasteners.

In addition to being conductive, these 17510 beryllium copper bars are non-sparking and non-magnetic, so they’re used in mines and oil rigs, as well as for navigational tools.

The most formable brass we offer, 260 offers better weldability than 300 series brass but it’s not as machinable. Sometimes called cartridge brass, it's commonly used for ammunition casings, radiator components, and decorative door hardware.

Polished on one side to a reflective, mirror-like finish.

With the highest lead content of all the brass alloys, 360 offers the best machinability. Often called free-machining and free-cutting brass, it stands up to high-speed drilling, milling, and tapping operations with minimal wear on your tools. It’s commonly used for gears, pinions, and lock components.

Polished on one side to a reflective, mirror-like finish.

Because 510 bronze is very strong and formable, it is the best choice for applications involving repetitive motion, such as springs and bellows.

Powdered bronze is pressed and then impregnated with SAE 30 oil to make this material self-lubricating.

These bars are precision ground on the top and bottom for a tight thickness tolerance of ±0.002".

Precision ground on the top and bottom, these bars have a tight thickness tolerance of ±0.002".

Cut this stock into custom shapes to fit your application.

Cut this shim stock into custom shapes to fit your application. Stock is made of layers of material bonded with adhesive; remove layers with a utility knife until you get the thickness you need.

Send us a drawing, and we'll cut your custom shim. Shims are made of layers of metal bonded with adhesive; remove layers with a utility knife until you get the thickness you need.