With a low-profile rounded head that’s flanged to sit flush for a finished appearance, these screws press threads into wood on cabinets, trim, molding, and light duty framing.

Brass screws are corrosion resistant in wet environments and electrically conductive.

18-8 stainless steel screws have good chemical resistance.

Beveled under the head for use in countersunk holes, these steel screws press threads into material for a tight, secure hold.

These steel screws are zinc plated to resist corrosion in wet environments.

18-8 stainless steel screws have good chemical resistance.

18-8 stainless steel screws have good chemical resistance.

Brass screws are corrosion resistant in wet environments and electrically conductive.

These Phillips head screws have a decorative rounded top that provides a finished appearance.

These steel screws are zinc plated to resist corrosion in wet environments.

These steel screws are zinc plated to resist corrosion in wet environments.

18-8 stainless steel screws have good chemical resistance.

Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.

18-8 stainless steel screws have good chemical resistance.

Also known as deck screws, these Phillips screws have a sharp point and narrow body to penetrate softwood and plastic-wood composite decking material.

Install these socket head screws through a hole and thread on a retainer to keep secure—no special tools are required.

Install these rounded head screws through a hole and thread on a retainer to keep secure—no special tools are required.

Install in soft material such as aluminum and low-carbon steel at least 0.036" thick with an arbor press or similar pressure tool.

The base flares out during installation, creating a backside flange in hard materials and near edges in panels up to 0.312" thick. Install with a flare-in installation tool and an arbor press.

An expanding rubber bushing damps vibration while holding panels together.

These wing-head screws have a clip-on nut that allows you to mount them near the edge of a thin panel. Use them to lock and release access panels, doors, and covers with a quarter-turn.

These rounded head screws have a nut that clips onto the edge of a thin panel, allowing you to mount the screw near edges. A quarter-turn locks and releases access panels, doors, and covers.

Press these wing head nuts into a closed-end hole or thick panel in applications where the back of the panel is inaccessible. A quarter-turn locks and releases access panels, doors, and covers.