Multiple thread channels (also known as thread starts) create faster linear travel than ball screws with a single thread start.

Multiple thread channels (also known as thread starts) create faster linear travel than ball screws with a single thread start.

Low-friction ball bearings allow these screw jacks to use half the power required by an Acme screw jack to lift the same load. Typically used as actuators, they run at higher speeds than Acme screw jacks.

Attach these fittings to the end of a ball screw jack to create pivoting connections with clevis rod ends and other linkages.

A set of ball bearings reduces friction and secures the end of a metric ball or lead screw.

With PTFE sleeve bearings and a low-friction ball screw, these slides don’t require the mess and maintenance of lubrication but still give you precise positioning anywhere along the length of their stroke.

With an included controller and an integrated stepper motor, these slides are a complete precision motion control system.

Smaller than any other actuator in our offering, these actuators’ short stroke length makes them good for automating fine, precise adjustments.