The thickness is oversized to allow for finishing to exact requirements.

An anodized coating bonds to the aluminum surface to improve wear and corrosion resistance.

More corrosion resistant and easier to form than multipurpose 6061 aluminum, 6063 is primarily used for exterior railings, decorative trim, and door frames.

6101 aluminum is chiefly used as a lightweight and economical alternative to copper in electrical applications, such as bus bars in switchboards and battery banks.

3000 series aluminum stands up to outdoor use, as well as exposure to chemicals. It offers a good combination of strength, formability, and weldability. It's often used for storage tanks, heat exchangers, garage doors, and general sheet metal work.

One side of these sheets is painted in your choice of gloss color, while the other side is painted gloss white.

A honeycomb core is bonded between two aluminum sheets for rigidity.

One side of these sheets and bars is polished to either a brushed finish or a mirror-like finish.

Highly corrosion resistant, 5083 is largely used around salt water for building ships and oil rigs. It maintains its strength in extreme cold, so it's also used to make cryogenic pressure vessels and tanks.

Made of 1000 series aluminum which is 99% pure, this aluminum offers superior formability, corrosion resistance, and electrical conductivity. It's frequently fabricated into raceways, decorative trim, and other parts where strength and hardness are not required.

Stronger than other marine-grade aluminum, 5456 is often used for pressure vessels and storage tanks in saltwater environments.

Choose between sheets and bars that are precision ground on all six sides or just on the top and bottom.

Also known as flat stock, these sheets and bars are precision ground on the top and bottom.

Create molds for vacuum-forming and thermoforming applications. Metapor aluminum is porous to let air and moisture escape, which prevents bubbles and blemishes.

Substitute 7050 aluminum for 7075 in structural applications when high stress-corrosion resistance is required. It is the same material that's used for bulkheads and fuselage frames.

Made of 5083 aluminum, these cast tool and jig plates are more corrosion resistant and respond better to anodizing than MIC6. This material is comparable to Alca 5 and ATP 5.